Filtri

Zadnje pregledano

STANDALONE 5-PAD CAPACITIVE TOUCH SENSOR BREAKOUT - AT42QT1070, ADAFRUIT 1362

  • Zaliha GALAGO: DA, 1 kom/da
    Zaliha DOBAVITELJ: DA, 39 kom/da
  • Dobava 7 dani
  • Marka: ADAFRUIT
  • Id broj: 498/55
10,48 €

 

 

 

This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed. 

 

Note that only one contact will be detected at once (this is to protect against having a hand brush against two or more contacts at once. 

 

Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout. 

 

The datasheet has many details on sensitivity, power usage, etc. - note that this board uses the chip in 'standalone' mode only, it cannot be used in I2C mode. 

Specifikacije

Glavno

Processor
Broadcom BCM2837B0, Cortex-A53 64-bit SoC @ 1.4 GHz
Memory
512MB LPDDR2 SDRAM
Connectivity
2.4 GHz and 5 GHz IEE 802.11.b/g/n/ac wireless LAN, Bluetooth 4.2/BLE
Access
Extended 40-pin GPIO header
Video & sound:
1 × full size HDMI

Dimenzije

Dolžina
99 mm
Širina
207 mm
Višina
208 mm
Opozorilo! Vsebina lahko vsebuje napake.