Proizvod trenutno nije na zalihi. Ispod se možete prijaviti i poslat ćemo vam obavijest kada će proizvod biti na zalihi. Obavijest ćete dobiti samo za ovaj proizvod.
Za traženi proizvod pošaljite poruku/upit nakon čega ćemo vas kontaktirati.
Za traženi proizvod pošaljite poruku/upit nakon čega ćemo vas kontaktirati.
DESCRIPTION
Control the flow of fluid using the flow of electrons! This liquid valve would make a great addition to your robotic gardening project. There are two 1/2" (Nominal non-taped National Pipe) outlets. Normally, the valve is closed. When 12VDC is applied to the two terminals, the valve opens and water can push through. The valve has a gasket arrangement inside, so there is a minimum pressure requirement of 0.02 Mpa (3 PSI). Also, liquid can only flow one direction.
Adafruit tried this solenoid at various DC voltages and found we could actuate it down at 6VDC (although it was a little slower to open). Here is the current draw table for various voltages. Adafruit suggest a TIP120 or N-Channel power FET with a 1N4001 kickback diode to drive this from a microcontroller pin. For a power supply, our 9V 1A or 12V 1A power adapters will do the job.
Voltage Current
6V 160 mA
7V 190 mA
8V 220 mA
9V 240 mA
10V 270 mA
11V 300 mA
12V 320 mA
These solenoids are not rated for food safety or use with anything but water.
TECHNICAL DETAILS
- 1/2" Nominal NPS
- Working Pressure: 0.02 Mpa - 0.8 Mpa
- Working Temperature: 1 ℃ - 75 ℃
- Response time (open): ≤ 0.15 sec
- Response time (close): ≤ 0.3 sec
- Actuating voltage: 12VDC (but we found it would work down to 6V)
- Actuating life: ≥ 50 million cycles
- Weight: 4.3 oz
- Dimensions: 3" x 2.25" x 2"